Manipulate Analytics not shown
Problem:
Some widgets of Manipulate Analytics on the Manipulate Setup page are empty or state “No data found”. An error message states “Unable to load graphs”.
Manipulate Analytics only shows new data
Note that even in the widgets that do display content, only data is shown that was collected after you updated to the version that introduced Manipulate Analytics. Earlier data is not shown. Once you have used Plauti Manipulate after the update (ran some actions) analytics will start to show.
Answer:
For the contents of Manipulate Analytics to show, Lightning Web Security should be used instead of Lightning Locker for protecting Lightning Web Components.
This can be set in Salesforce Setup > Session Settings > Lightning Web Security: Use Lightning Web Security for Lightning web components and Aura components.
If Lightning Web Security is enabled, Manipulate Analytics should all be visible. Please contact Plauti Support if this is enabled yet the Manipulate Analytics widgets are still empty.
If Lightning Web Security is disabled, Lightning Locker still is in use and not all graphics for Manipulate Analytics can be displayed. Contact your Salesforce Administrator to change this. After enabling the setting, make sure to do a hard refresh in you browser.